Automatic Transmission Dipstick for Chrysler Jeep Dodge - Level Tool with Directions check auto trans fluid oil level -Dealer #s : 8863B, 9336, 9336A, 42RLE, NAG1, 62TE 2.7 3.5 3.6 3.7 5.7 6.1 6.4 4.5 out of 5 stars 583
See full list on 700r4transmissionhq.com
I have a Late 99 F250SD with 7.3 and Auto trans. Just started my truck this morning and backed it up 3 feet and I was putting on my new cold air intake and during my install i notice trans fuild on the floor.Followed it and saw it was coming from the top of dipstick tube, pulled out my dip stick...
2004R TH400 TH350 Transmission Dipstick and Tube This universal dipstick is designed to work with all Chevrolet, Pontiac, Oldsmobile, Buick and Cadillac 65-91 GM 200, 200C, 400-4R, 350, 350C and 400 transmissions.
Common symptoms are: erratic shifting, slipping or losing trans fluid without a source of a leak. You have a modulator on the rear of the transmission on the C4 / C5 and the C6 units. The modulator is on the passenger's side of the transmission on the C3. Pull the vacuum line off the mod.
Remove the rear dip stick (transmission) and wipe it with a rag, reinsert it completely. Repeat the procedure and note the level, which should be between or in the hash marks (towards the end of dip stick) and add accordingly. If the level is okay you will have to check with transmission shops and the Ford dealer for quotes ( and check on Google ).
May 03, 2005 · 6 - I used a regular floor jack to support my transmission as I removed it, but I needed one person to handle the jack, and 2 people under the car to get the transmission out. As I said, mine was a manual, and I believe that the manual is lighter than an automatic. I found my 4+3 to be quite heavy, so be careful if you decide to remove the ...
1. Drain transmission by removing the black oil pan bolts and work towards the front slowly (if dipstick is attached to the pan, dipstick removal will allow most oil to drain). 2. Remove the eight valve body attaching bo lts and remove valve body by pulling straight down. 3. Install transbrake valve body into transmission carefully.
A transmission flush is a process in which the fluid in an automatic transmission is flushed out of the transmission and replaced with new ATF. The flushing process, when done correctly, replaces nearly 100% of the old fluid with new fluid, including fluid in the torque converter and oil cooler lines. Doing A C4 to AOD Transmission Upgrade. When you get the transmission try to get all of the related stuff (bolts, electrical connector, dipstick tube, converter, yoke, block plate, linkages, levers, shifter, hydraulic fittings, etc.), will make this project a lot easier.